Peg In Hole
- Robot
- Hexarotor + arm
- Trials
- 1
- Time limit
- 20 s
- Step limit
- 2,400
The hovering aerial manipulator starts holding a metal peg (a cylinder 15 cm long and 4 cm in diameter) in its gripper, pointing straight ahead. A wall stands ahead with a blue square socket mounted on its front face: a square frame whose square opening faces the robot and is closed at the back by a red plate. Insert the peg: the centre of the peg's front end (the end pointing ahead at the start) must be inside the square opening and more than 2 cm deep into it (the opening is 3 cm deep up to the red plate).
Official Embodied First Exam clipSource ↗
SuccessPass/fail
Insert the peg: the centre of the peg's front end must be inside the square opening and more than 2 cm deep into it.
Full criteria and notes
- Full success check
- Success at a control step when the peg tip p = peg root position + R(peg) (0.075, 0, 0) (the centre of the end face that points ahead at reset), expressed in the socket's frame as q = R(socket)^T (p - socket root position), satisfies q.x more than 0 (peg insertion depth min = 0: past the socket's mid-plane, i.e. more than 0.02 m behind its front face; the red plate's surface is at q.0.01), |q.y| less than 0.03 s and |q.z| less than 0.03 s (half the scaled opening side 0.06 s); all inequalities strict. Only this point is tested: the peg's orientation, whether it is still held and contacts are not checked. AM-Bench reports no subtask criteria for this task. Evaluated after every control step (decimation 1, so after every 1/120 s physics step) on the simulated state; no hold time is required. The episode terminates at the first step where it holds.
- Scoring
- A simulator error or a missing result counts as a fail.
- Trials
- 1 graded attempt per test (standard mode: one live episode, no replay).
Embodied First Exam